On November 20, 2026, SAIC General Motors released a new generation of plug-in hybrid technology-Zhenlong plug-in hybrid MAX, which will be the first to be equipped with a new Buick MPV in Jingshijia, and will be unveiled to the public at the Guangzhou Auto Show on November 27. This system consists of a 2.0T hybrid-specific engine, an 800V high-voltage platform, and a plug-in hybrid-specific battery that supports 6C charging.
According to reports, Zhenlong plug-in hybrid MAX is based on the unique physical architecture advantages of plug-in hybrids. Compared with Zhenlong plug-in hybrid and Zhenlong plug-in hybrid Pro, it has been further upgraded in terms of performance, quietness, safety and intelligence.
Power: The difference between full power and low power acceleration is 0.1 seconds.
Zhenlong plug-in hybrid MAX is equipped with General Motors' first 2.0T hybrid-specific engine, a plug-in hybrid electric drive with a WLTC operating efficiency of 93.07%, and an 800V high-voltage architecture. The system has a comprehensive maximum power of 550kW and a peak torque of 815N·m. SAIC-GM said that the battery can still release 460kW of power at 20% SOC to support power output in the state of power loss.
The official measured data shows that the new Zhijing Shijia equipped with the Zhenlong plug-in hybrid MAX accelerates from 0 to 100km/h in 5.7 seconds for full power and 5.8 seconds for full power; it accelerates overtaking from 80 to 120km/h, and takes 3 seconds for both full power and power loss; and accelerates from 100-140km/h, it takes 3.2 seconds for both full power and power loss. In the power-depletion state, the vehicle's maximum cruising speed is 190km/h, and it also meets the power-non-attenuation test of 30 consecutive full-throttle accelerations.
In terms of battery life, the new Zhijing Shijia equipped with the Zhenlong plug-in hybrid MAX 67-degree plug-in hybrid battery has a pure electric range of 402km. When traveling long distances, Zhenlong plug-in hybrid MAX is equipped with a new generator with a peak power of 135kW, a continuous performance ratio of 74%, and a stable output of 100kW, which is equivalent to a 2C charging capacity during driving.
Quietness: Starting with the balance shaft gear and motor
The noise of the hybrid system mainly comes from two sources: engine operation and high-frequency howling of the motor. The targeted plan of Zhenlong Plug and Mix MAX also falls in these two places.
On the engine side, Zhenlong plug-in hybrid MAX's 2.0T hybrid-specific engine uses "double PEEK balance shaft gears". The gear material is PEEK (polyetheretherketone). Similar materials are used in the aerospace field. Official data shows that compared with traditional metal balance shaft gears, this design can reduce noise by up to 5dBA.
In addition, the engine also adopts a three-pronged approach of noise source control, transmission path optimization and noise isolation. It adopts many acoustic solutions, including roller chain and full sprocket HNBR rubber covering design, integrated AEM rubber damping front cover, sandwich intake manifold acoustic wrapping, PUR-V0 grade high-pressure oil pump and high-pressure oil rail acoustic wrapping, as well as high-rigidity deformation-resistant cylinder and crankshaft designs.
(Double PEEK balance shaft gear silent technology)
To address motor whistling that is easily ignored, the static drive motor of the Zhenlong plug-in hybrid MAX adopts a 72-slot V-shaped chute design, which improves the acoustic performance by 3dB under the same working conditions, which is equivalent to a 50% reduction in acoustic energy.
Battery: Focusing on “zero lithium precipitation” and fast charging temperature control
Data released by SAIC-GM show that the Autoneng battery equipped with the Buick Zhijing new energy model has traveled a total of 7.2 billion kilometers without spontaneous combustion. The hybrid-specific battery of the Zhenlong plug-in hybrid MAX goes a step further, featuring "zero lithium precipitation", that is, there will be no lithium precipitation during 6C fast charging and full-cycle use. Officials claim that this can achieve "same life as the car and battery" and solve users' concerns about "the battery may be damaged by common fast charging."
Supporting "zero lithium precipitation" is battery thermal management technology. Zhenlong's plug-in hybrid MAX hybrid special battery adopts a multi-sided liquid cooling design, which increases the cooling capacity by 130%. The maximum battery temperature during fast charging is 15°C lower than the national standard limit. The side cooling is a 4-layer water-cooling flow channel. With the U-shaped fluid distribution design, the flow distribution uniformity is controlled within 5%, so that the temperature difference of the battery cells under fast charging conditions is less than 5°C, and the temperature difference of the battery cells under daily operation conditions is less than 2°C.
In terms of BMS, SAIC-GM said that the new battery management system can set the lithium precipitation boundary and intervene in advance; Pan Asia's n-Tau battery algorithm controls the SOC estimation error within 2%.
Energy management: Use navigation data to allocate fuel and electricity in advance
In terms of energy scheduling, Zhenlong plug-in hybrid MAX uses edge AI on the vehicle end to uniformly schedule the energy domain and power domain. The core is an "AI spatio-temporal planning" system: it combines navigation information to plan the SOC trajectory and automatically allocate the proportion of fuel and electricity. Users do not need to manually switch modes.
In specific scenarios, when the system determines that the current power is insufficient to cover the navigation mileage, it will store electricity in advance and switch to pure electric driving about two kilometers before reaching the destination.
The chassis is equipped with "preview torque distribution" technology, which integrates lidar and camera perception to identify the road ahead in advance and dynamically distribute torque between the front and rear wheels to reduce slipping. The control strategy will also be combined with driving style, common routes and working condition distribution, and will be continuously modified on the car end, so that the hybrid system will become more and more suitable for the car owner's habits and needs as it is used. (Leifeng.com (public account: Leifeng.com))
edit
Resend Email Modify Email




